Derui – Complete Test Equipment for Two-Wheelers & E-Scooters

02/03/2025
FROM VEHICLE INSTALLATION TO USEFUL TEST EVIDENCE Electric Motorcycle Testing Starts with a Repeatable Setup A change in tyre condition, restraint or cooling can make two runs difficult to compare—even when the motorcycle has not changed. Specify the installed condition as carefully as the load programme. Discuss Derui’s electric motorcycle test bench for evaluating an assembled vehicle through its driven tyre and a dynamometer roller arrangement. Start with the question your team needs to answer, then review the vehicle fixture, loading system and measurement channels. This gives engineering and procurement teams a clearer basis for comparing equipment proposals. Development Compare vehicle changes Plan controlled comparisons of vehicle variants or settings, with the installation, preparation and operating conditions recorded. Loaded running Define the duty Specify the speed, load, duration and cooling needed to investigate behaviour during the agreed operating programme. Production planning Separate screening from endurance A short release check and a development endurance run need different sequences, handling and acceptance evidence. Vehicle installationLoad programmeMeasurementsConfigurationAcceptanceFAQs Fit the Motorcycle Before Specifying the Test Provide wheelbase, vehicle dimensions and mass, tyre diameter and width, ground clearance, suspension movement and driven-wheel layout. Identify whether the project uses a hub motor or a transmission-driven rear wheel, and whether any front-wheel or dual-wheel drive must be accommodated. Keep the vehicle and test lane aligned For the illustrated rear-wheel arrangement, the motorcycle’s front and rear wheel centre planes follow the same longitudinal line as the front locator, rear roller station and loading route. A vehicle positioned diagonally across the bed changes the contact and restraint conditions; it is not a substitute for suitable fixtures. Review wheel location, permitted restraint points, suspension position and clearances with a representative vehicle. Define tyre pressure and condition, tie-down settings and any preparation between runs. A rear-wheel test layout is not automatically…
